Cannondale Lefty Dlr Manual

Cannondale Lefty Dlr Manual 4,9/5 391 reviews

• 2:1(56 0$18$/ 6833/(0(17 /HIW 0$;  /HIW -DNH 31    READ THIS MANUAL CAREFULLY! It contains important safety information. • IMPORTANT MANUAL INFORMATION FAILURE TO FOLLOW THE WARNINGS CONTAINED IN THIS MANUAL CAN RESULT IN SERIOUS INJURY OR DEATH. Information important to your safety is distinguished in this manual by the following notations: The safety alert symbol means.“ATTENTION!

With this design Cannondale has a system that rolls and does not slide like other suspension forks. Lefty 0SS100 DLR—Air/Oil Damper. Manual Lock Out. StopLock Mount Tech NoteView PDF Owner's Manual SupplementView PDF. LEFTY SUPERMAX 2.0 (2015). LEFTY SPEED SL, DLR, 29er (2010).

BECOME ALERT! YOUR SAFETY IS INVOLVED.”. • Product Features.4 WARNING Lefty MAX TPC+.4 This manual adds important safety, maintenance, POTENTIAL HAZARD Lefty Jake. • 8' Rotor Compatible Boot HOW TO AVOID THE HAZARD • International Disc Brake Compatible If you observe any of the above, DO NOT RIDE. Take the fork to an Authorized Cannondale • 8' Rotor Compatible Boot Dealer to have it inspected and serviced. • (1) The disc brake acts a secondary wheel wheel between your knees, and trying to twist the retention device. An improperly installed rotor Your Cannondale Owner’s Manual (Cannondale handlebars from side to side.

The bars should not could allow the front wheel to come off of the Owner’s Manual for Multi-speed Bicycles) includes a. • bolt the brake rotor onto the hub, be sure that the brake line should pass from the lever through the two NOTE: seals rests against the large cartridge bearing and cable guides on the outside of the fork leg. The brake line should not be held tightly in the that the rotor holds the seal in place. • Rear brake line and rear derailleur cable bolt or bearing be sure to reinstall the cap with a from the brake disc (rotor). Take note of any small amount of grease on the cap threads.

Shims present and be sure to reinstall them The rear brake line and rear derailleur cable should later during reassembly. • clockwise to loosen it. CAUTION: Take extra measures to protect the Lefty axle CAUTION: spindle from damage when the wheel is removed. Dents, scratches, or other damage Make sure the spindle (threads and the from a fall or drop to the ground could spindle shaft) are completely clean before severely damage the spindle preventing the.

• Do not mount the magnet in any manner that will interfere with the proper functioning of the front disc brake. Consult the manufacturer’s mounting instruc- tions/ Have an Authorized Cannondale Dealer install a ride computer. Pickup sensor Wheel magnet. • Sag is the distance the fork compresses when you Four is the maximum number of preload sit on the bike with your static weight. Adjusting shims recommend by Cannondale. If you preload affects the amount of sag. We recommend The shims are located between the top washer.

• Lefty compresses. When installing springs, be sure to use the  The blue compression adjuster of the Lefty Max appropriate Bottom-Out and Preload spacer located at the bottom of the fork leg. Which are included in the spring kits. See FORK SPRING table below.

• Do not force the adjuster beyond the stops! Rebound damping - slows (or resists) the speed your Lefty extends after being compressed. The red rebound adjuster of the Lefty Max  and Lefty Jake  is located at the top of the fork leg. • Make sure that the disc brake tubing has not rubbed a hole into the boot. If the tubing is rubbing on the boot, you should reroute it to elim- inate the contact.

Your Cannondale retailer can assist you with this procedure. • Take your steps every other month as well as checking for bicycle to an authorized Cannondale retailer where a boot - severe structural damage inside the fork needle bearing migration. If your fork is a Lefty Jake, proceed to step 7. Pour the specified oil volume into the bottom If your fork is a Lefty MAX, with it upside- 5. Use a 22mm socket to carefully remove the of the fork. Then slide the fork downward until the bottom of the upper collar meets the top of the upper 16.Install the blue compression knob onto the Lefty MAX.

CAUTION: TORQUE: Set screw - 9.0 Lbf•in (1.0 N•m). • TORQUE: Outer cap - 89.0 lbf•in (10.0N•m). Any metal preload shims that may have been If you are working on a Lefty MAX, be sure to added.

Ada banyak mode yang dapat kalian mainkan seperti Mode Story atau Gaiden Story Mode yang menjanjikan peperangan turnamen yang emosional khas para prajurit khas negeri tirai bambo. Game ini mempunyai nama lain yang berjudul Sengoku Basara 2 Eiyuu Gaiden yang merupakan kelanjutan cerita atau expansion dari Sengoku Basara 2. Untuk

With the washer against the underside of the. • 30mm open ended wrench. Whats app for blackberry 9220. MAX - to install the red clicker rebound adjustment knob onto a Lefty MAX, install both JAKE - Remove the red rebound adjustment springs into the black outer cap. Knob by loosening (not removing) the 2mm Allen wrench and lifting the knob off. • Resetting migrated needle bearings.